1955 Evinrude Aquasonic Fleetwin 7.5 hp Decal Set

This Evinrude decal set includes:

• Evinrude decal - Port Side
• Evinrude decal - Starboard Side
• Aquasonic bird decal - Port Side
• Aquasonic bird decal - Starboard Side
• Starting and Operating instructions under cover decal
• Evinrude Fleetwin 7.5 decal front
• Starting & Operating instruction decal

Starting & Operating instruction decal decal reads:

STARTING & OPERATING INSTRUCTIONS

1. ATTACH FUEL HOSE CONNECTOR TO MOTOR.
2. PUSH PUMP BUTTON ON FUEL TANK UNTIL IT RESIST THUMB PRESSURE.
    This must be done whenever carburetor is empty.
3. SET TWIST GRIP AT “START” POSITION.
4. SET SHIFT HANDLE TO “NEUTRAL” POSITION.
5. LARGE HISH SPEED ADJUSTING KNOB SHOULD BE SET AT 3. (Below 40 F at 5)
6. PULL OUT CHOKE FOR “COLD MOTOR”.
    Choke normally not required for “Warm Motor”.
7. PULL STARTER HANDLE.
8. PUSH IN CHOKE WHEN MOTOR STARTS.
9. SHIFT INTO “FORWARD” POSITION, TURN TWIST GRIP TO “FAST” AND ADJUST LARGE
    KNOB TO BEST OPERATION. SLOW MOTOR DOWN AND ADJUST SMALL KNOB TO
     BEST OPERATION WHEN MOTOR IS WARM AND IDLING.
10. TO STOP MOTOR, TURN TWIST GRIP TO “STOP” POSITION.

FUEL & LUBRICATION:
    MIX ONE-HALF PINT MOBILOIL OUTBOARD WITH EACH GALON OF REGULAR GASOLINE.
    WE RECOMMEND MOBILOIL OUTBOARD OR ANOTHER OUTBOARD OIL, OR A REGULAR
    S.A.E. 30 GRADE AUTOMOTIVE ENGINE OIL. AVOID USE OF LOW PRICED THIRD
    GRADE (ML) OILS.
GEAR HOUSING LUBRICANT: WE RECOMMEND MOBILUBE GX90 OR ANY OTHER GOOD
   GRADE OF S.A.E. 90 AUTOMOTIVE (HYPOID) GEAR LUBRICANT. IF HYPOID LUBRICANT
   IS NOT AVAILABLE, IN EMERGENCY, USE MOBILOIL OUTBOARD OR ANY OTHER S.A.E.
   30 ENGINE OIL UNTIL RECOMMENDED LUBRICANT CAN BE OBTAINED.
CHECK YOUR GEAR CASE FOR OIL AFTER FIRST FIVE HOURS OF OPERATION TO BE SURE
    IT IS FILLED. THEN CHECK PERIODICALLY AT LEAST EVERY 50 HOURS. DRAIN & REFILL
    AT THE END OF THE SEASON.
    SPARK PLUG: USE CHAMPION J-6-J OR ELECTRIC AUTO-LITE A3X.

 READ YOUR INSTRUCTION BOOK
EVINRUDE MOTORS  MILWAKEE, WISCONSIN, U.S.A.